新闻中心banner
Your current location: 首页 > News > Company news > Matters needing attention in production of slitting line machine
Industry news Company news

Company news

Matters needing attention in production of slitting line machine

Source:     Time:2021-02-25 Hits:

In the production process of the slitting line machine, we need to pay attention to many issues to ensure the quality of the material after slitting. In today's article, Wuxi Bangzhou Machinery will take you to understand the precautions in the production process of the slitting line machine, so that everyone can have a deeper understanding of the slitting line machine.

 

1. Be careful not to touch the coil of slitting line machine when feeding.

 

2. Manually adjust the coils on the uncoiler. Normally, the coil must be aligned to ensure that the width of the two cut edges is as consistent as possible. In special cases, when there is a large crack or other defect on the side of the material, the width of the two cutting edge is not consistent, but the horizontal position of the coil on the uncoiler must be adjusted manually, and it is confirmed that the edge defect of the blank can be completely removed.

 

3. Check the thickness and width of incoming material before production can be carried out.

 

4. When the material coil with a thickness of more than 0.5mm is removed from the steel belt, the roller must be used to prevent the coil from being thrown.

 

5. The material should be positive when wearing, and the material should not be crooked or wrinkled. It is strictly prohibited to wipe the rollers at the entrance to avoid getting involved.


 3x650 automatic slitting line


6. In the process of cutting slitting line machine steel , when marks and scratches caused by the machine are found on the surface of the plate, the guide rollers on the guide road should be stopped and checked timely. If any prominent particles are found, they should be polished with sandpaper and then cleaned with alcohol.

 

7. Pay close attention to the surface quality of incoming materials during the operation of the machine. According to the requirements of the quality and acceptance standard of steel slitting line machine, if it is found to be unqualified, it must stop the machine and find relevant technical quality personnel to deal with it.

 

8. Before each roll of material is produced, a sheet of material should be cut, and the production can be carried out in accordance with the technological requirements of the length and width on the card. If not, it is necessary to adjust the parameters of scissors, otherwise it is not allowed to continue production.

 

9. When lifting the finished products, it is necessary to carefully inspect the crane and rigging, and command and operate overhead travelling cranes to concentrate. Operators are prohibited from standing in small and unsafe places to prevent material from swinging.

 

10. In case of equipment failure in production, stop immediately and inform the maintenance staff to deal with it.

 

Wuxi Bangzhou Machinery is one of the best steel slitting machine manufacturers with high-quality steel slitting production lines. After decades of development, Wuxi Bangzhou Machinery has become a leading steel slitting company in this field and exporting high-quality slitting line machines to the world. Bangzhou Machinery is committed to providing quality services and quality products.



Related news: