The last article introduced part of the safe operating procedures of the slitting machine. Today this article introduces the rest. Let's take a look together.

Slitting machine is used to slit silicon steel sheet, aluminum coil, galvanized coil, stainless steel, carbon steel and other coils into several small strips along the length direction.

The equipment composition of the slitting machine generally includes: uncoiler, guide device, uncoil tension device, cutting head shear, threading table, looper, disc shear, guide roller, machine train transfer roller, imported clamping device, constant tension coil Take device, edge shredder, scrap car, coiler, liner device, etc.

1. Before hanging the copper belt, check the spreader to see if there is any damage to prevent damage to the equipment.

2. Run the equipment dry for 2-3 minutes before loading, observe the operating conditions of each part, and operate after the equipment is operating normally.

3. When loading, pay attention to whether the position of the inner hole of the copper coil is correct. If the position of the height direction of the coil is found to be incorrect, stop the movement of the loading trolley immediately and re-adjust the position before centering.

4. Wipe the knife shaft and frame archway before starting to remove the debris and waste on and around the equipment.

5. It is necessary to start the uncoiler and disc cutter when cutting the belt, and it is forbidden to thread the belt during high-speed operation. When starting to cut, the back tension pad should be lowered to press the copper strip, and then the air bag should be inflated to keep the copper strip stable during cutting. During the cutting process, it is strictly forbidden to stand on the front of the reel to prevent the broken belt from hurting people.

6. When adjusting the copper tape, you must wear gloves to hold the copper. When pulling the copper belt, the palm of your hand should not be close to the edge of the copper belt to prevent the edge of the copper belt from hurting your hands. During operation, it is strictly forbidden to operate between the blades by hand, and it is strictly forbidden to touch the edge of the copper belt by hand. The adjustment should be slowed down during adjustment.

7. Before starting the winder, check whether all the belts are clamped, and when normal, start high-speed winding. After the coiling is completed, the tape rolls must be bundled to prevent the tape rolls from loosening.

8. When the tail of the copper strip is cut out of the disc, the looper table must be moved to the center of the unit to prevent the copper strip from entering the bottom of the looper pit from scratching the copper strip.

9. When recycling waste, no one should stand in front of the scrap edge coiler to prevent the waste from smashing your feet.

10. When installing the copper strip, it should be steady and slow to prevent damage to the equipment and the copper strip.

11. If the equipment is found to be faulty during operation, the machine should be shut down in time to notify the mechanics to eliminate the fault, and the equipment should not be caused to work.

12. During the operation and maintenance of the equipment, it is not allowed to cross the moving parts. It is forbidden to touch the rotating parts, and do not cross the safety fence.

13. When the equipment is not used for 8 hours, the main power switch should be turned off.

Wuxi Bangzhou Machinery Manufacturing Co., Ltd. is a company specialized in steel coil straightening machine, slitting line, cut to length line and flat bar straightening and chamfering machine. Our company is a professional slitting machine manufacturer. If you are interested in slitting machines, don’t hesitate to contact with us.