Safety matters of high-speed splmachine
The split-cutting machine has a set of its own safety operation procedures, as follows:
1. The input voltage is three fire lines and one zero line. Hold the porcelain handle so as to avoid electric shock.
2. Use the internal hexagonal wrench every day to check whether the reel cross screw is firm every day, and tighten it in time if it is loose.
3. Keep the whole machine clean, wipe the oil in time and remove the wrapped plastic strip.
4. Material dressing: The two large rubber shafts on the cutting machine can not be worn, so as to avoid injury.
5. Distinguish the edge selection of the electric eye, distinguish between manual and automatic, you can move the scroll left and right when manual, and dial it to manual when shutting down.
6. It is appropriate to adjust the left and right devices with the hand wheel, so as to close the car contact in the middle of the two switches.
remarks: When continuous cutting, measure the position of the paper pipe and make the paper pipe together with the membrane.
The large tension is determined according to the thickness and width of the film. Small, the principle is that the membrane is thick, wide when the tension should be large, the membrane is thin and narrow when the tension is small.Tension can be checked by tapping the membrane with the hand.
Use the machine to zero in time: speed adjustment back to zero, tension adjustment back to zero, turn off the eye box switch.Then pull the power off.
If any fault or abnormal noise, stop and check the repair personnel.
matters need attention:
1. Ensure that the voltage, current and hydraulic equivalent value are correct and stable before startup.
2. Before the equipment is ready for operation, all personnel must inform them to leave the equipment to ensure personal safety before starting the operation.
3. When the split-cutting machine is running, do not touch the film roll or roll core in operation by hand, so as not to involve the hand and cause personal injury.
4.During the operation, do not cut or cut each roller core with a knife or a hard object.
Wuxi Bangzhou Machinery Manufacturing Co.,Ltd, located in Changjing Town of Wuxi, is a company specialized in steel coil straightening machine, slitting line, cut to length line and flat bar straightening and chamfering machine.Feel free to contact us if you feel interested in our products.
Related news: